Back to top

1969 Allied Seabreeze 35

Sister Bay, Wisconsin

$40,000

Fresh Water - One of A Kind Sailboat - Seabreeze

Basic Boat Info

Boat Name: Dawn Piper
Make: Allied
Model: Seabreeze 35
Year: 1969
Condition: Used
Category: Sail
Builder: Allied
Designer: MacLear & Harris
Construction: Fiberglass
Boat Hull ID: USB10635B969
Has Hull ID: Yes
Keel Type: Centerboard Keel

Dimensions

Length: 35 ft
Length Overall: 34'6 ft
Waterline Length: 24 ft
Beam: 10'3 ft
Max Draft: 7 ft
Min Draft: 3'10 ft
Cabin Headroom: 6'3 ft
Electrical Circuit: 12v
Cabins Count: 2

Engines / Speed

Engines: 1
  • Make: Westerbeke
  • Model: D902
  • Fuel: Diesel
  • Engine Power: 42hp
  • Type: Inboard
  • Propeller Type: 3 BladeBronze
  • Drive Type: Direct

Tanks

Fuel Tanks: 1
Fuel Tank Capacity: 30 gal
Water Tanks: 1
Water Tank Capacity: 60 gal
Holding Tank Count: 1

Other

Heads Count: 1
Drive Type: Direct
Boat Class: Yawl

Contact

Emmett Cregan
YACHT WORKS

Office

WI
P.O. Box 199
Sister Bay, WI, US, 54234
Tel:855-900-2628
Disclaimer
The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.


Description

The keel- and- centerboard hull, of which Finisterre was an inspired prototype, has revolutionized the design of the modern offshore racing yacht. Seabreeze was a highly refined example of the type. MacLear and Harris have incorporated in her design the lessons learned from years of observation of sea-going center boarders. Sea breeze has a 4,000-pound lead keel to give her great stiffness with moderate draft. Her centerboard nestles within the keel, to reduce wetted surface and increase speed off the wind. She has a fine entrance, a clean run, and a long keel for easy steering in a following sea. Below decks the Seabreeze's generous beam and fiberglass construction. She has six berths without the abomination of uppers; a large galley; a realistic chart table; a profusion of lockers, drawers, and bins; and a fine feeling of spaciousness everywhere.

Deck & Hull

Hull one-piece fiberglass-reinforced plastic with an integrally molded centerboard trunk. Hull is both longitudinally and transversely reinforced. The one-piece insulated deck, trunk cabin and cockpit are of specially engineered sandwich construction to insure highest strength and stiffness with least weight. The non-skid is molded flush , to minimize wear and chipping. The 4,000 lb. lead ballast keel is glassed securely inside the hull.

Interior

A complete headliner gives a smooth, clean interior overhead, and there are no exposed fiberglass surfaces to detract from the below-decks shipshape appearance enhanced by natural teak. Main and forward stateroom bunks are 6'3" with 4"thick mattresses. Four wide extension transoms pull out to make two additional 6'6" berths. Easily accessible storage areas are provided under main cabin bunks. Headroom 6' in main cabin and 6' in toilet area and forward stateroom, with 10 sq. ft. of galley counter and work area excluding stove and SS sink; 100 lb. ice box with 8 cu. ft. of storage capacity, toilet room with sink, laundry hamper, linen and medicine storage, mirror and light, three opening ports with screens, and two 4" dorade ventilators opening into main cabin and toilet room-all make for comfortable living below.

Deck Fittings

All SS or Bronze of American manufacture, with specially engineered stemhead fitting incorporating bow chocks and pulpit base. 10 1/2" bow cleat, rope deck-pipe leading into forepeak, four 6" jib sheet cleats, one 6" main sheet cleat, two 8" stern cleats, two 6" stern chocks, two #5 jib sheet winches, one #2 jib, halyard winch, one #2 main sheet winch, SS life lines and bow pulpit.

Spars & Rigging

Spars are extruded and drawn aluminum with Ys" nickel silver sail track and tapered elliptical aluminum spreaders. The aluminum boom is equipped with 4" roller reefing. Rigging %" SS 1 x 19 wire with 1;2" bronze turnbuckles with toggles. Stainless steel chain plates bonded to hull and deck and thru-bolted to bulkheads wherever functional.

Electrical

12-Volt with 2 heavy-duty batteries complete with safety switch and fuse panel, engine room exhaust blower, navigation lights, 6 screw-type cabin lights.

Construction

Long straight keel makes Seabreeze steady on the helm. Centerboard is wholly housed inside the keel and it’s hoisting pennant runs below the cabin sole, leaving all interior space clear and uncluttered.

Disclaimer
The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.
Additional Contact Information
Kurtis Sandmire
Cell: (920) 639-1491
Email: kurtis@yachtworks.com